Card Type	Fax, Modem (synchronous/asynchronous), Network Interface Card
Chip Set	Unidentified
NIC Type	Ethernet
Maximum Modem Rate	28.8Kbps
Maximum Fax Rate	14.4Kbps
Data Bus	PCMCIA
Fax Class	Class I & II
Data Modulation Protocol	Bell 103/212A ITU-T V.21, V.22, V.22bis, V.23, V.32, V.32bis, V.34
Fax Modulation Protocol	ITU-T V.17, V.27ter, V.29, V.21 CH2
Error Correction/Compression	MNP5, V.42, V.42bis
Topology	Star
Wiring Type	Unshielded twisted pair

SUPPORTED COMMAND SET

Basic AT Commands

AT, A/

A, B, D, E, H, M, O, P, Q, T, V, X, Y, Z

&C, &D, &F, &T, &V, &W

Extended AT Commands

\K, \N

%E, %Q

S Registers

S0, S1, S2, S3, S4, S5, S6, S7, S8, S9, S10, S11, S12, S24, S25, S26, S29, S30, S32, S33

S37, S38

Note: See MHI Help file for full command documentation.

AUTODETECT
Type:	Configuration
Format:	AT [cmds] Fn [cmds]
Description:	Selects auto-detect mode

AUTO-MODE DETECTION
Type:	Configuration
Format:	AT [cmds] Nn [cmds]
Description:	Selects various options for the automatic detection and negotiation of protocols during the handshake process if the modem is communicating with a remote modem of dissimilar speed.
Command	Function
N0	Auto-mode detection disabled
íN1	.Auto-mode detection enabled

DATA SET READY (DSR)
Type:	Configuration
Format:	AT [cmds] &Sn [cmds]
Description:	Selects DSR options
Command	Function
&S0	DSR forced high
&S1	DSR high only while modem is handshaking or connected

GUARD TONE
Type:	Configuration
Format:	AT [cmds] &Gn [cmds]
Description:	Commands the modem to transmit a guard tone in V.22/V.22bis
Note: Used primarily for international data transmission
Command	Function
&G0	Guard tone disabled
&G1	Guard tone disabled
&G2	1800Hz guard tone enabled

PULSE DIALING RATIO
Type:	Configuration
Format:	AT [cmds] &Pn [cmds]
Description:	Selects pulse dial make/break ratio
Command	Function
&P0	39/61ms at 10pps (North America)
&P1	33/67ms at 10pps (Europe)

REPORT INFORMATION
Type:	Immediate
Format:	AT [cmds] In [cmds]
Description:	Displays information requested
Command	Function
I0	Reports product code

RESPONSE MESSAGE
Type:	Configuration
Format:	AT [cmds] Cn [cmds]
Description:	Returns OK message
Command	Function
C1	Reports OK