P I O N E E R S G 3 2 2 0 A T QUANTUM NO MORE PRODUCED Native| Translation ------+-----+-----+----- Form 3.5"/SLIMLINE Cylinders | | | Capacity form/unform 3200/ MB Heads | | | Seek time / track 12.0/ ms Sector/track | | | Controller IDE / ATA2 FAST/ENHA Precompensation Cache/Buffer KB Landing Zone Data transfer rate MB/S int Bytes/Sector 512 MB/S ext Recording method operating | non-operating -------------+-------------- Supply voltage Temperature *C | Power: sleep W Humidity % | standby W Altitude km | idle W Shock g | seek W Rotation RPM read/write W Acoustic dBA spin-up W ECC Bit MTBF h Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** QUANTUM PIONEER SG JUMPER SETTING +---------------------------------------------------------+ | |XX | |XXI | |XXN | |XXT | |XXE | |XXR | |XXF | |XXA | |XXC | |XXE | |XX1 | |xx | |xx | | | |XX Power | |XX +---------------------------------------------------------+ ********************************************************************** J U M P E R S ********************************************************************** QUANTUM PIONEER SG JUMPER SETTING Jumper Setting ============== ATA CABLE PIN+ Not Used +--------------------------------------1----------++--------+ |* * * * * * * * * * * * * * * * * * * * * * * * *| XXXXXX | |* * * * * * * * * * * * * * * * * * * * * * *| xxxxxx | +--------------------+----------------------+-+-+--+-Power--+ Blank key DS+ | PK CS Single Drive = DS only Master Drive = DS only Slave Drive = No Jumpers Quantum IDE disk drives have multiple jumper setting options and are used to set specific drive features. The most common settings are used to define the drive as the primary or secondary drive on the IDE cable. Master / Slave -------------- Quantum IDE drives have additional jumper settings used for optional features found on the drive. Listed below are the various jumper options that may be found on Quantum IDE drives and the corresponding feature that they enable. DS Jumper - Drive Select ------------------------ Used to identify the drive as the primary (MASTER) drive in a single or dual drive configuration. This is the factory default setting. SP Jumper - Slave Present ------------------------- Used only when the second (SLAVE) drive in a two drive configuration does not support DASP. DASP ---- (Drive active / drive 1 present) is a CAM (Common Access Method) defined signal that indicates the presence of a second drive, DASP is used during power on initialization and after a reset. Prior to this definition, products were introduced which did not utilize this method to detect the presence of a second drive. The SP jumper is used on the MASTER drive, with the DS jumper, when the second drive does not support DASP. CS Jumper - Cable Select ------------------------ Only used in systems that support the cable select feature. Cable Select allows for each IDE disk drive to be jumped the same and the position on the cable determines the ID. This requires a special cable and both drives on the interface would have to support this feature. PK Jumper - Park (Spare) ------------------------ This jumper does not enable any feature. It is used, instead, to provide a spare location to any jumper removed from the drive during a configuration change. ********************************************************************** G E N E R A L ********************************************************************** NEVER Announced but never produced. NEVER PRODUCED!!!