D P R A - 2 1 2 1 5 T R A V E L . X P IBM Native| Translation ------+-----+-----+----- Form 2.5"/SUPERSLIMLINE Cylinders | 2358| | Capacity form/unform 1200/ MB Heads | 16| | Seek time / track 12.0/ 4.0 ms Sector/track | 63| | Controller IDE / ATA2 FAST/ENHA Precompensation Cache/Buffer 64 KB READ/WRITE Landing Zone Data transfer rate 5.000 MB/S int Bytes/Sector 512 11.100 MB/S ext PIO3 Recording method operating | non-operating -------------+-------------- Supply voltage 5 V Temperature *C 5 55 | -40 65 Power: sleep 0.1 W Humidity % 8 90 | 5 95 standby 0.3 W Altitude km -0.300 3.000| -0.300 12.000 idle 1.3 W Shock g 100 | 300 seek 2.6 W Rotation RPM 4900 read/write 2.6 W Acoustic dBA spin-up W ECC Bit 128BIT REED SOLOMON,ENHANC... MTBF h 300000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** IBM DPRA-20810/21215 TRAVELSTAR XP JUMPER SETTING +--------------------------------------+ | | | | | | +--------Interface-------------47------+ | **********************1 **45 Jumper | *************x********* **46 | +------44----------------------48------+ + + Pin position 20 is left blank for secure connector insertion. Pin position 45 through 48 are used for drive address setting. ********************************************************************** J U M P E R S ********************************************************************** IBM DPRA-20810/21215 JUMPER SETTING Jumper Setting ============== Drive address ------------- A jumper is available at the interface connector to determine the drive address. Using Cable Selection, the drive address depends on the condition of pin 28 of the AT interface cable. In the case when pin 28 is ground or low, the drive is a Master. If pin 28 is open or high level, the drive is a Slave. ---47--45+ * * X | Master * * X | (Default setting) ---48--46+ ---47--45+ * * * | Slave * * * | No Jumper ---48--46+ ---47--45+ * * * | Cable Selection * xxx | ---48--46+ ********************************************************************** I N S T A L L ********************************************************************** -ANY DIREC. Notes on installation ===================== Installation direction ---------------------- horizontally vertically +-----------------+ +--+ +--+ | | | +-----+ +-----+ | | | | | | | | | +-+-----------------+-+ | | | | | | +---------------------+ | | | | | | | | | | | | | | | | | | +---------------------+ | +-----+ +-----+ | +-+-----------------+-+ +--+ +--+ | | | | +-----------------+ The drive will operate in all axis (6 directions).